2016 Iowa Code
Title V - AGRICULTURE
Chapter 215 - INSPECTION OF WEIGHTS AND MEASURES
Section 215.18 - Specifications and tolerances.
215.18
Specifications and tolerances.
The specifications, tolerances, and other technical requirements for commercial, law enforcement, data gathering, and other weighing and measuring devices, as adopted by the national conference on weights and measures and published in the national institute of standards and technology, handbook 44, “Specifications, tolerances, and other technical requirements for weighing and measuring devices”, shall apply to weighing and measuring devices in this state, except insofar as modified or rejected by rule and shall be observed in all inspections and tests.
[C50, 54, 58, 62, 66, 71, 73, 75, 77, 79, 81, §215.18]
90 Acts, ch 1084, §8
Referred to in §215A.3
Disclaimer: These codes may not be the most recent version. Iowa may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
