2017 Vermont Statutes
Title 9 - Commerce and Trade
Chapter 74 - Energy Efficiency Standards For Appliances And Equipment
§ 2795 Efficiency and water conservation standards
§ 2795. Efficiency and water conservation standards
The Commissioner shall adopt rules in accordance with the provisions of 3 V.S.A. chapter 25 establishing minimum efficiency standards for the types of new products set forth in section 2794 of this title. The rules shall provide for the following minimum efficiency standards for products sold or installed in this State:
(1) Medium voltage dry-type distribution transformers shall at a minimum meet the efficiency requirements set forth for such transformers in 10 C.F.R. § 431.196, as those requirements may be amended from time to time.
(2) Metal halide lamp fixtures designed to be operated with lamps rated greater than or equal to 150 watts but less than or equal to 500 watts shall not contain a probe-start metal halide ballast.
(3)(A) Residential furnaces and residential boilers shall meet or exceed the following Annual Fuel Utilization Efficiency (AFUE) and electricity ratio values:
Product Type Maximum Maximum
AFUE Electricity
ratio
Natural gas- and propane- 90% 2.0%
fired furnaces
Oil-fired furnaces ≥ 83% 2.0%
94,000
Btus/hour in
capacity
Oil-fired furnaces < 83% 2.3%
94,000
Btus/hour in
capacity
Natural gas-, oil-, and 84% Not applicable
propane-fired hot water
residential boilers
Natural gas-, oil-, and 82% Not applicable
propane-fired steam
residential boilers
(B) AFUE shall be measured in accordance with the federal test method for measuring the energy consumption of furnaces and boilers contained in Appendix N to subpart B of part 430, Title 10, Code of Federal Regulations.
(C) The Commissioner may adopt rules to exempt compliance with these residential furnace or residential boiler AFUE standards at any building, site, or location where complying with these standards would be in conflict with any local zoning ordinance, building or plumbing code, or other rule regarding installation and venting of residential boilers or residential furnaces.
(4)(A) Single-voltage external AC to DC power supplies shall meet the energy efficiency requirements of the following table:
Nameplate output power Minimum efficiency in Active
Mode
0 to < 1 watt 0.49* Nameplate Output
≥ 1 watt and ≤ 49 watts 0.09*Ln(Nameplate Output
power) + 0.49
> 49 watts 0.84
Maximum Energy Consumption
in No-Load Mode
0 to < 10 watts 0.5 watts
≥ 10 watts and ≤ 250 watts 0.75 watts
* Where Ln (Nameplate Output) = Natural logarithm of the nameplate output expressed in watts.
(B) This standard applies to single voltage AC to DC power supplies that are sold individually and to those that are sold as a component of or in conjunction with another product. Single voltage AC to DC power supplies that are made available by a product manufacturer as accessories, service parts, or spare parts for its products manufactured prior to January 1, 2008 shall be exempt from the requirements of this standard.
(C) For purposes of this subdivision (4), the efficiency of single-voltage external AC to DC power supplies shall be measured in accordance with the test methodology specified by the U.S. Environmental Protection Agency's Energy Star Program, "Test Method for Calculating the Energy Efficiency of Single-Voltage External AC-DC and AC-AC Power Supplies (August 11, 2004)."
(5)(A) State-regulated incandescent reflector lamps shall meet the minimum average lamp efficacy requirements for federally regulated incandescent reflector lamps contained in 42 U.S.C. § 6295(i)(1)(A).
(B) The following types of incandescent reflector lamps are exempt from these requirements:
(i) lamps rated at 50 watts or less of the following types: BR30, ER30, BR40, and ER40;
(ii) lamps rated at 65 watts of the following types: BR30, BR40, and ER40; and
(iii) R20 lamps of 45 watts or less.
(6) In the rules, the Commissioner shall adopt minimum efficiency and water conservation standards for each product that is subject to a standard under 10 C.F.R. §§ 430 and 431 as those provisions existed on January 19, 2017. The minimum standard and the testing protocol for each product shall be the same as adopted in those sections of the Code of Federal Regulations.
(7) In the rules, the Commissioner shall adopt a minimum efficacy standard for general service lamps of 45 lumens per watt, when tested in accordance with 10 C.F.R. § 430.23(gg) as that provision existed on January 19, 2017. (Added 2005, No. 152 (Adj. Sess.), § 1; amended 2009, No. 159 (Adj. Sess.), § 14, eff. June 4, 2010; 2017, No. 42, § 4, eff. May 22, 2017.)
