There is a newer version
of
this Section
2022 Utah Code
Title 41 - Motor Vehicles
Chapter 6a - Traffic Code
Part 12 - Railroad Trains, Railroad Grade Crossings, and Safety Zones
Section 1205 - Railroad grade crossings -- Certain vehicles must stop -- Exceptions -- Rules.
Universal Citation: UT Code § 41-6a-1205 (2022)
Effective 5/4/2022
41-6a-1205. Railroad grade crossings -- Certain vehicles must stop -- Exceptions -- Rules.
Amended by Chapter 104, 2022 General Session
41-6a-1205. Railroad grade crossings -- Certain vehicles must stop -- Exceptions -- Rules.
- (1) An operator of a commercial motor vehicle, as defined under Section 53-3-102, shall upon approaching a railroad grade crossing:
- (a) except as provided in Subsection (2), slow down and check that the tracks are clear of an approaching railroad train or other on-track equipment;
- (b) stop within 50 feet, but not closer than 15 feet, from the nearest rail of the railroad track before reaching the crossing if the tracks are not clear;
- (c) obey all traffic control devices or the directions of a peace officer, or other crossing official at the crossing; and
- (d) before proceeding over a railroad grade crossing:
- (i) ensure that the vehicle has sufficient space to drive completely through a railroad grade crossing without stopping; and
- (ii) ensure that the vehicle has sufficient undercarriage clearance to safely and completely pass through the crossing.
- (2) Except as provided in Subsection (3), the operator of a vehicle described in 49 CFR 392.10:
- (a) shall stop within 50 feet, but not closer than 15 feet, from the nearest rail of the railroad track before crossing, at grade, any track of a railroad;
- (b) while stopped, shall:
- (i) look in both directions along the railroad track for:
- (A) a sign of an approaching railroad train or other on-track equipment; or
- (B) a signal indicating the approach of a railroad train or other on-track equipment; and
- (ii) listen for a signal indicating the approach of a railroad train or other on-track equipment;
- (i) look in both directions along the railroad track for:
- (c) may proceed across the railroad track only when reasonably safe to cross; and
- (d) after stopping and safely proceeding, may not manually shift gears while crossing the railroad track.
- (3) This section does not apply at a:
- (a) railroad grade crossing where traffic is controlled by a peace officer or other crossing official;
- (b) railroad grade crossing where traffic is regulated by a traffic-control signal;
- (c) railroad grade crossing where a traffic-control device gives notice that the stopping requirements of this section are not applicable; or
- (d) other railroad grade crossings excluded under 49 CFR 392.10.
- (4) A violation of this section is an infraction.
Amended by Chapter 104, 2022 General Session
Disclaimer: These codes may not be the most recent version. Utah may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
