2012 Utah Code
Title 15A - State Construction and Fire Codes Act
Article 3 - Statewide Amendments Incorporated as Part of State Construction Code
Section 310 - Amendments to Chapter 10 of IPC.
(1) In IPC, Section 1002.4, the following is added at the end of the paragraph: "Approved Means of Maintaining Trap Seals. Approved means of maintaining trap seals include the following, but are not limited to the methods cited:
(a) A listed trap seal primer conforming to ASSE 1018 and ASSE 1044.
(b) A hose bibb or bibbs within the same room.
(c) Drainage from an untrapped lavatory discharging to the tailpiece of those fixture traps which require priming. All fixtures shall be in the same room and on the same floor level as the trap primer.
(d) Barrier type floor drain trap seal protection device meeting ASSE Standard 1072.
(e) Deep seal p-trap".
Amended by Chapter 297, 2013 General Session
Disclaimer: These codes may not be the most recent version. Utah may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
