2015 Oregon Revised Statutes
Volume : 11 - Public Health, Housing, Environment
Chapter 466 - Hazardous Waste and Hazardous Materials II
Section 466.065 - Applicant for renewal to comply with ORS 466.055 and 466.060; exceptions; permit conditions; rules.

OR Rev Stat § 466.065 (2015) What's This?

As a condition to the issuance of a renewal permit under ORS 466.005 to 466.385 and 466.992, the Environmental Quality Commission may require the applicant to comply with all or some of the criteria set forth in ORS 466.055 and 466.060, except that any application for a renewal permit for a treatment or disposal facility located off the site of waste generation and operating on July 15, 1999, shall not have to comply with ORS 466.055 and 466.060 unless the applicant proposes a different type of treatment or disposal than has been authorized for use at any time at the facility. In issuing any renewal permit for such a facility, the commission shall include in the permit conditions that require all of the following:

(1) The facility is limited to acceptance of hazardous waste or PCB for treatment or disposal in an amount not to exceed 110 percent of the amount of hazardous waste or PCB treated or disposed by the facility under any permit. The Department of Environmental Quality shall approve acceptance of a greater amount of hazardous waste or PCB for treatment or disposal as part of a permit renewal or modification process if the applicant demonstrates that a greater amount of hazardous waste or PCB is necessary either to protect or to provide a higher level of protection of the public health and safety or of the environment.

(2) The facility complies with all applicable federal and Oregon technological requirements for treating and disposing of hazardous waste or PCB.

(3) The facility meets property line setback requirements established by the commission by rule.

(4) The facility owner, any parent company of the owner and the operator comply with all applicable Oregon and federal requirements for financial and technical capability to properly construct and operate the facility.

(5) The facility owner or operator owns or contracts with an emergency response provider or coordinator that can provide for timely response to a spill or release in Oregon of hazardous waste or PCB being transported to the facility by a motor vehicle owned by the owner or operator of the facility.

(6) Any person hired by the owner or operator of the facility to transport hazardous waste or PCB to the facility owns or has a contract with an emergency response provider or coordinator that can provide for timely response to a spill or release in Oregon of hazardous waste or PCB being transported by a motor vehicle to the facility.

(7) Upon arrival at the facility of any motor vehicle transporting hazardous waste or PCB not described in subsection (5) or (6) of this section, the owner or operator of the facility shall request to review the transporter’s authorization to transport hazardous waste or PCB in Oregon and the driver’s authorization to drive a motor vehicle transporting hazardous waste or PCB in Oregon. The owner or operator of the facility shall report to the department the name of any transporter or driver failing to demonstrate authorization.

[1985 c.670 §6; 1987 c.540 §20; 1999 c.740 §4]

Disclaimer: These codes may not be the most recent version. Oregon may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.