There is a newer version of this Section
2017 Georgia Code
Title 40 - Motor Vehicles and Traffic
Chapter 6 - Uniform Rules of the Road
Article 7 - Negotiating Railroad Crossings, Entering Highways From Private Driveways
§ 40-6-143. Moving heavy equipment at railroad grade crossings
Universal Citation: GA Code § 40-6-143 (2017)
- (a) No person shall operate or move a crawler-type tractor, steam shovel, derrick, roller, or any equipment or structure having a normal operating speed of ten miles per hour or less or a vertical body or load clearance of less than one-half inch per foot of the distance between any two adjacent axles or in any event of less than nine inches, measured above the level surface of a roadway, upon or across any tracks at a railroad grade crossing without first complying with this Code section.
- (b) Notice of any such intended crossing shall be given to a station agency of such railroad and a reasonable time shall be given to such railroad to provide proper protection at such crossing.
- (c) Before making any such crossing, the person operating or moving any such vehicle or equipment shall first stop it not less than 15 feet nor more than 50 feet from the nearest rail of such railroad and while so stopped shall listen and look in both directions along such track for any approaching train and for signals indicating the approach of a train and shall not proceed until the crossing can be made safely.
- (d) No such crossing shall be made when warning is given by automatic signal or crossing gates or a flagman or otherwise of the immediate approach of a railroad train or car. If a flagman is provided by the railroad, movement over the crossing shall be under his direction.
Disclaimer: These codes may not be the most recent version. Georgia may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.