2016 Colorado Revised Statutes
Title 12 - Professions and Occupations
General
Article 25 - Engineers, Surveyors, and Architects
Part 1 - Engineers
§ 12-25-117. Professional engineer's seal - rules
(1) Upon receiving a license from the board, a professional engineer may obtain a crimp type seal, a rubber stamp type seal, or an electronic type seal of a design approved by the board. The seal must contain the licensed professional engineer's name and license number and the designation "Colorado licensed professional engineer". Colorado professional engineers licensed before July 1, 2004, may continue to use their prior existing seals.
(2) Repealed.
(3) A professional engineer shall use a seal and signature only when the work to which the seal is applied was prepared under the engineer's responsible charge.
(4) (Deleted by amendment, L. 94, p. 1493, § 17, effective July 1, 1994.)
(5) The board shall adopt rules governing use of the seal and the retention, use, and distribution of sealed documents and copies thereof.
Disclaimer: These codes may not be the most recent version. Colorado may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
