2013 Code of Alabama
Title 40 - REVENUE AND TAXATION.
Chapter 12 - LICENSES.
Section 40-12-177 - Veneer mills, planing mills, box factories, etc.
Each person, firm, or corporation engaged in the operation of a veneer mill, planing mill, box factory, handle factory or any other factory where lumber or timber is sawed or made into a finished or semifinished product, other than a sawmill licensed under Section 40-12-154, shall pay a privilege tax based on the number of men employed or engaged in the manufacture of the products produced by such mills, as follows: Where there are five or less men employed or so engaged, $5; where there are more than five men and less than 10 so employed or engaged, $10; where there are 10 men and less than 20 so employed or engaged, $30; where there are 20 men and less than 40 so employed or engaged, $80; and where there are 40 men and over, $120. It is the intention hereof that where a person, firm, or corporation shall pay a privilege tax under Section 40-12-154 or under Section 40-12-121, then no privilege license tax shall be charged or collected hereunder.
(Acts 1936-37, Ex. Sess., No. 231, p. 279; Code 1940, T. 51, §614.)Disclaimer: These codes may not be the most recent version. Alabama may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
